Have you ever come to a stop, and as your foot hits the brake, your car starts to shake? Well, that is what we call judder. Judder is a vibration that can be felt in the seat or steering wheel, but it will not cause pulsing of the brake pedal. In this Tire Review Continental Tire Garage Studio video, we dive into why this happens and how to fix it.
Judder can occur in a vehicle with zero runouts or disc thickness variation, or DTV, and is caused by brake torque variation, or BTV. DTV is a variation in thickness of the disc rotor braking surfaces as it rotates on the axle. And BTV occurs when there is a variation of torque across the face of the rotor that causes the rotor to slip and catch as brake pads pinch the rotor. BTV may be caused by an inconsistent rotor finish, metallurgy, or uneven deposits of the friction material on the face of the rotor.
Knowing the difference between pulsation or DTV and BTV is critical to solving any brake complaint and avoiding a problem in the first place. Assuming that new pads and rotors will automatically fix the problem will only create more issues with the customer when the vehicle inevitably comes back.
The friction between the rotor finish and transfer layers changes forward motion and braking force into heat, but there is a lot of science that goes into what happens at the molecular level to make that happen.
Most semi-metallic brake pads use the two different surface materials of the pad and rotor to make friction. The abrasive action wears away the two surfaces, but ceramic and some non-asbestos organic pads transfer a thin layer of pad material onto the surface of the rotor. The transfer layer is bonded to the rotor’s surface and cannot be washed away by water or wheel cleaners. The only way to remove it is by using a brake lathe or abnormal heat. With this type of pad, it is critical to machine the rotor with the correct surface finish and follow the recommended break-in procedure to establish the transfer layer.
Adherent friction is easier on rotors, but the pads become the primary wear component. The layer is always worn and replenished by the brake pad during braking, so these pads produce dust. The smoothness of the friction surface of a rotor is described in terms of microfinish or RA factor. RA stands for “roughness average” and represents a way to measure the smoothness of a rotor. Most lathes on the market will yield very acceptable RA factors when they are in good condition and are used properly.
The finish is essential to transfer material for organic and ceramic friction materials. The correct finish is also critical for semi-metallic pads so that they can have the correct coefficient of friction during the initial break-in.
To stop judder in your car, it is vital to look at rotor finish, metallurgy or uneven deposits of the friction material on the face of the rotor. Looking at all these variables is the only proper way to understand what is causing brake torque variation. I’m Brian Coote coming to you from the Tire Review Continental Tire Garage Studio. Thanks for watching!
Garage Studio: The Best Way to Deal With Tire Safety Recalls
Garage Studio: CV Joint Replacement Tips
Garage Studio: Servicing 4×4 Locking Hubs
Garage Studio: Keeping Up With Increasing Tire Sizes
Passenger/Light Truck: Tires for Pickup Trucks are Picking Up Speed
TPMS: TPMS Service Basics: That’s Right, It Can Be That Simple
Service: ADAS Calibration: Sensor Operation & Calibration Myths
Commercial Tires: Hercules Introduces Strong Guard H-MA Commercial Tire
Business Operations: What Do Your Signs Say About Your Shop?
The Best Way to Deal With Tire Safety Recalls
Keeping Up With Increasing Tire Sizes
Factors That Affect a Tire’s Rolling Resistance